The Dodge Console Vault is custom made to fit in the existing OEM lower console tub.  No special tools are needed.

When you look inside your OEM tub you will see 4 screws, one in each corner. 
These are all you have to remove and replace.  No drilling or modifications are required to your vehicle or center console.

This shows the OEM screw that is found in each corner or somewhere in a vehicle's existing console tub.  Each vehicle might have these screws in different locations, but all will be at the bottom.

Simply use a Phillips screwdriver to unscrew the OEM screw.

Once the screws are removed, your Dodge Console Vault is ready to install.

Slide the Dodge Console Vault into place. The Console Vault is customized to the size of the existing opening.

Once the Dodge Console Vault is slid into place, open the vault door.

Use your hand to make sure the Dodge Console Vault is fully seated against the bottom of the OEM lower tub. 

Since the Console Vault is a custom it, you may have push down on the front section to make sure it is properly seated.

Once seated, your should be able to run your finger across the front of the existing OEM tub ridge and run it back across the front lip of the Dodge Console Vault. 

The Console Vault should be flush, or a little bit lower of the front ridge of the OEM tub.

Once seated, you do not use the old OEM bolts (in the center). They are too short and are to be replaced with the included bolts.

The existing OEM tub, along with your new Dodge Console Vault is secured to the frame of the truck, which is underneath the OEM tub.

You place the bolts in each hold and begin the thread process with your fingers until snug.

Tighten down until the bolt is flush with the bottom of the Dodge Console Vault.

The Console Vault is now bolted to the truck frame, providing strong anti-theft protection for items left inside your console.

The only thing left to do is reset the combination of the lock located on the top of the console vault.  This is easy to do and the instructions are provided. 

This photograph shows the final installation photo of the Dodge Console Vault. 

The Console Vault is well made, and looks like it came standard from the factory, can cannot be seen from the outside of the vehicle.